Welcome to Wikk Industries, Inc. - Products - Door Switches

Transmitters, Receivers & Hard-wired Accessories
Add Remote Control Versatility to Wikk AccessAbility^TM

Transmitters

DESCRIPTION and MOUNTING SYSTEM	300 and 310 FREQUENCY
HAND OPERATED One and two button models with power to operate at full distance. Each button operates one channel with 10-position dip switch to provide 1,024 codes.	1TRANSM300 1TRANSM310 1 1/2" X 2" X 1/2" Deep (38 X 51 X 12 mm) 12 Volt Battery (A23 series batteries NOW AVAILABLE at Walgreen’s, True Value and Ace Hardware stores, Batteries Plus and Radio Shack)
	1TRANSL300 1TRANSL310 3 3/4" X 2 1/2" X 3/4" Deep (95 X 64 X 19 mm) 9 Volt Battery
	2TRANSM300 2 1/2" X 1 1/2" X 1/2" Deep (64 X 38 X 12 mm) 12 Volt Battery (A23 series batteries NOW AVAILABLE at Walgreen’s, True Value and Ace Hardware stores, Batteries Plus and Radio Shack)
	2TRANSL300 3 3/4" X 2 1/2" X 3/4" Deep (95 X 64 X 19 mm) 9 Volt Battery
Four channel transmitter offers complete control of up to four separate operations.	4TRANSL300 3 3/4" X 2 1/2" X 3/4" Deep (95 X 64 X 19 mm) 9 Volt Battery
SWITCH TRANSMITTERS (SWTRAN) Compatible with: SURF SQ 4 & 6, SURF 6R, WKS-4RF, N4RS, N6RS	SWTRAN300 SWTRAN310 2 1/4" X 2 1/4" Board (57 X 57 mm) 9 Volt Battery
SWITCH TRANSMITTERS (SWTRAN M) Compatible with: the INGRESS’R SURF6/P, SURF 4R, WKS4-RF, SURF SFA, JSB and Single Pole Momentary Key Switches	SWTRAN300M SWTRAN310M 1 1/2" X 2" X 1/2" Deep (38 X 51 X 12 mm) 12 Volt Battery Offers a high degree of weather resistancy (A23 series batteries NOW AVAILABLE at Walgreen’s, True Value and Ace Hardware stores, Batteries Plus and Radio Shack)
BOLLARD TRANSMITTERS (BOLTRAN) Compatible with: Bollard Posts with Acrylic Caps	BOLTRAN300 BOLTRAN310 3 3/4" X 2 1/2" X 3/4" Deep (95 X 64 X 19 mm) 9 Volt Battery

Receivers

RECEIVER 1 CHAN

RECEIVER 2 CHAN

3.6” W x 5.25” H x 1.5” D
Dual Frequency and Power Compatibility

• Handles 300MHz (Multi-Code) and 310 MHz (Stanley) (Frequency recognition by jumper setting)
• Auto-sensing 12-24 Volts AC or DC (12-30V AC and 10.5-30V DC)
• Built-in RF test points for audio troubleshooting equipment
• 1 channel model: 10 dips set 1,024 system codes
• 2 channel model: 9 dips set 512 system codes, 1 sets channel
• Dry contacts

Supplied with:
• 9.5 inch 75 Ohm whip antenna
• 3 ft. 75 Ohm coaxial cable
• Bulkhead connector for remote antenna location
• Mounting hardware

Alternative Switching Accessories (Hard-wired)

SEQUENCE & LOCK RELAY
(SEQ. & LOCK RELAY)
This device is used between the actuating switch and the door operator to create a momentary delay, allowing an electric strike or electric panic device to release before the door begins to open. 1 3/4" L x 2 1/2 W x 1" H

ALTERNATE ACTION RELAY
(ALT ACT'N RELAY)
This device is an impulse relay used to change the normal momentary action of a wall switch to maintained, for Push to Open-Push to Close door operator activation. Wiring schematic available.
1 7/8" L x 1 5/8" W x 2 7/8" H

24 VOLT TRANSFORMER
(24V 40VA TRANS)
24 volt, 1.6 amp transformer.
Reduces 120 volts to 24 volts.

2 1/2" L x 2 1/4" W x 1" H

Picture Not Available